winfast的tv2000

[ricky]

請問有人有安裝的經驗嗎!?
在官網上似乎沒有linux的driver~~~

請各位高手幫忙~~thx

[阿信]

小弟不清楚您的tv2000是那一版的，以前的版本是用 bttv 的 module，kernel-2.4 就有支援了。(最好是看卡上得晶片)

另外在 XFree86 的設定檔中加入 v4l 這個 module 就能用xawtv 全螢幕播放。v4l 只有支援 bttv 而已。

[mike0]

小弟的kernel是2.6.12.3
Linux debian 2.6.12.3 #2 Wed Jul 20 00:34:19 CST 2005 i686 GNU/Linux

指令
modprobe -a bttv
modprobe -a tuner

用xawtv和fftv都OK,可是有時後換台怪怪的
要rmmod才行,還要再研究看看
rmmod -v tuner
rmmod -v bttv
rmmod -v video_buf
rmmod -v v4l2_common
rmmod -v btcx_risc
rmmod -v tveeprom
rmmod -v videodev


lspci
0000:02:09.0 Multimedia video controller: Brooktree Corporation Bt878 Video Capture (rev 02)
0000:02:09.1 Multimedia controller: Brooktree Corporation Bt878 Audio Capture (rev 02)



dmesg
Linux video capture interface: v1.00
bttv: driver version 0.9.15 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
ACPI: PCI Interrupt 0000:02:09.0[A] -> GSI 21 (level, low) -> IRQ 217
bttv0: Bt878 (rev 2) at 0000:02:09.0, irq: 217, latency: 64, mmio: 0xefefe000
bttv0: detected: Leadtek WinFast TV 2000 [card=34], PCI subsystem ID is 6606:217d
bttv0: using: Leadtek WinFast 2000/ WinFast 2000 XP [card=34,autodetected]
bttv0: gpio: en=00000000, out=00000000 in=00f3ff07 [init]
bttv0: using tuner=5
bttv0: i2c: checking for MSP34xx @ 0x80... not found
bttv0: i2c: checking for TDA9875 @ 0xb0... not found
bttv0: i2c: checking for TDA7432 @ 0x8a... not found
bttv0: i2c: checking for TDA9887 @ 0x86... not found
tuner 4-0063: chip found @ 0xc6 (bt878 #0 [sw])
tuner 4-0063: type set to 5 (Philips PAL_BG (FI1216 and compatibles))
bttv0: registered device video0
bttv0: registered device vbi0
bttv0: registered device radio0
bttv0: PLL: 28636363 => 35468950 .. ok
bttv0: add subdevice "remote0"
bttv0: PLL can sleep, using XTAL (28636363).
bttv0: unloading
Linux video capture interface: v1.00
bttv: driver version 0.9.15 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
ACPI: PCI Interrupt 0000:02:09.0[A] -> GSI 21 (level, low) -> IRQ 217
bttv0: Bt878 (rev 2) at 0000:02:09.0, irq: 217, latency: 64, mmio: 0xefefe000
bttv0: detected: Leadtek WinFast TV 2000 [card=34], PCI subsystem ID is 6606:217d
bttv0: using: Leadtek WinFast 2000/ WinFast 2000 XP [card=34,autodetected]
bttv0: gpio: en=00000000, out=00000000 in=00ffff07 [init]
bttv0: using tuner=5
bttv0: i2c: checking for MSP34xx @ 0x80... not found
bttv0: i2c: checking for TDA9875 @ 0xb0... not found
bttv0: i2c: checking for TDA7432 @ 0x8a... not found
bttv0: i2c: checking for TDA9887 @ 0x86... not found
tuner 4-0063: chip found @ 0xc6 (bt878 #0 [sw])
tuner 4-0063: type set to 5 (Philips PAL_BG (FI1216 and compatibles))
bttv0: registered device video0
bttv0: registered device vbi0
bttv0: registered device radio0
bttv0: PLL: 28636363 => 35468950 .. ok
bttv0: add subdevice "remote0"